Important Alert Items - Fujitsu MBA3073NC Product Manual

Important Alert Messages
The important alert messages in this manual are as follows:
Task
Installation Damage
Never remove any labels from the HDD or deface them in any way.
High temperature
To prevent injury, never touch the HDD while it is hot. The DE and LSI
become hot during operation and remain hot immediately after turning off the
power.
Data loss
1. The user must not change the setting of terminals not described in this
section. Do not change setting status set at factory shipment.
2. Do not change the setting of terminals except following setting pins
during the power is turned on.
• Write protect: Pin pair 9/10 of the CN2 setting terminal
3. To short the setting terminal, use the short plug attached when the device
is shipped from the factory.
Damage
1. Make sure that system power is off before connecting or disconnecting
cables.
2. Do not connect or disconnect cables when power is on.(except NC model)
Damage
1. Be careful of the insertion orientation of the SCSI connectors. With the
system in which terminating resistor power is supplied via the SCSI cable,
if the power is turned on, the overcurrent protection fuse of the
terminating resistor power supplier may be blown or the cable may be
burnt if overcurrent protection is not provided.
When the recommended parts listed in Table 4.2 are used, inserting the
cables in the wrong direction can be prevented.
2. To connect SCSI devices, be careful of the connection position of the
cable. Check that the SCSI device with the terminating resistor is the last
device connected to the cable.
C141-E270

Important Alert Items

A hazardous situation could result in minor or moderate personal injury if the
user does not perform the procedure correctly. This alert signal also indicates
that damages to the product or other property may occur if the user does not
perform the procedure correctly.
Alert message
(NP model only)
Page
50
71
75
82
82
3