Control Settings - GE GFDR480EFWW Installation Instructions Manual

Installation instructions
Hide thumbs Also See for GFDR480EFWW:
Table of Contents

Advertisement

Available languages

Available languages

Control settings.

3
4
5
6
7
6
Add Time
Press to add time to the Steam Dewrinkle,
Warm Up, Air Fluff or Time Dry cycles.
Dry Temp
You can change the temperature of your dry
cycle.
High
For regular to heavy cottons.
Medium
For synthetics, blends and items labeled Permanent Press.
Low
For delicates, synthetics and items labeled Tumble Dry Low.
Extra Low For lingerie and special-care fabrics.
No Heat
This option may only be used with Air Fluff, in which items are tumbled without
heat.
Sensor Dry Level
The sensor continuously monitors the amount of
moisture in the load. When the moisture in your
clothes reaches your selected dry level, the dryer
will stop.
Extra Dry
Use for heavy-duty fabrics or items that should be very dry, such as towels.
(on some models)
More Dry
Use for heavy or mixed type of fabrics.
Dry
Use for normal dryness level suitable for most loads. This is the preferred cycle for
energy saving.
Less Dry
Use for lighter fabric (ideal for ironing).
Damp
For leaving items partially damp.
Start/Pause
Press to start a dry cycle. If the dryer is
running, press it once and it will pause the
dryer. Press it again to resume the dry cycle.
My Cycle
Set up your favorite combination of settings
and save them here for one touch recall.
These custom settings can be set while a cycle
is in progress.
To store a My Cycle combination of settings:
1. Select your drying cycle.
2. Change Temp and Level settings to fit your
needs.
3. Select any drying options you want.
4. Press and hold the My Cycle button for 3
seconds to store your selection. A beep will
sound and the button will light up.
NOTE: Sensor dry Level only works with
Cottons, Normal, Active Wear, Delicates,
Speed Dry, Bulky, Towels/Sheets, Sanitize
and Steam Dewrinkle cycles.
To recall your stored My Cycle combination:
Press the MY CYCLE button before drying a
load.
To change your stored My Cycle
combination:
Repeat steps 1–4.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents