Each Mode Setting (Mp Model Only) - Fujitsu MAM3184MC/MP Product/Maintenance Manual

Table 5.1
1. Set the SCSI ID so that there are no duplicates between SCSI devices on
the same SCSI bus.
2. The priority of SCSI bus use in ARBITRATION phase is determined by
SCSI ID as follows:
7 > 6 > 5 > 4 > 3 > 2 > 1 > 0 > 15 > 14 > 13 > 12 > 11 > 10 > 9 > 8
5.3.2

Each mode setting (MP model only)

(1) Setting terminator power supply
Refer to Table 5.2 for controlling the supply of power from the drive to the SCSI terminator power
source (TERMPOW). For information on MP model, refer to Figures 5.2 and 5.3.
Table 5.2
Supply on/off of SCSI terminator power from IDD
SCSI ID setting (CN2 on MP model only)
SCSI ID
7-8 5-6
0 Open Open
1 Open Open
2 Open Open
3 Open Open
4 Open Short
5 Open Short
6 Open Short
7 Open Short
8 Short Open
9 Short Open
10 Short Open
11 Short Open
12 Short Short
13 Short Short
14 Short Short
15 Short Short
IMPORTANT
Setting SCSI terminator power supply (MP model only)
Supply off
Supply on
C141-E134-01EN
CN2
3-4 1-2
Open Open
Open Short
Short Open
Short Short
Open Open
Open Short
Short Open
Short Short
Open Open
Open Short
Short Open
Short Short
Open Open
Open Short
Short Open
Short Short
CN2 23-24
Open
Short
(default)
(default)
5 - 7