Dell 2355dn Multifunction Mono Laser Printer Network Manual page 17

Once you have configured the printer, you may want to print a
9
Configuration Page to confirm your settings.
Press Setup
a
Press the Next (
b
Press the up/down arrows to select Reports.
c
Press the up/down arrows to select Network Settings.
d
NOTE:
After completing the connection, you can check the
information.
Press Setup
a
Press the Next (
b
Press the up/down arrows to select Network Setup.
c
Press the up/down arrows to select Wireless.
d
Press the up/down arrows to select WLAN Signal.
e
Confirm the AP's SSID name and status.
f
Method 3:
Dell printers contain an Embedded Web Server (EWS) that can be accessed
from a compatible web browser over the internet. The EWS provides
management and configuration access for the Dell printer including its
network and wireless settings. The printer IP address is required to access its
Embedded Web Server.
NOTE:
The Dell Internal Wireless Adapter is shipped in Ad-Hoc mode by default. To
configure the Dell Internal Wireless Adapter in Ad-Hoc mode, you must access the
printer's Embedded Web Server using a direct connection to your computer. This is
only recommended for advanced users.
Identifying the printer's IP address
Turn on the printer.
1
There are two ways to access the printer from your computer.
Either;
• Connect the supplied Ethernet cable to connect the printer to a LAN
network port/ router.
This guide can be used for Dell™ laser printers 5330dn, 2335dn, and 2355dn
Machine Setup from the home screen.
) button.
Machine Setup from the home screen.
) button.
AP's SSID
15