Fujitsu C141-E090-02EN Product Manual page 101

At command issuance (I/O registers setting contents)
1F7 (CM)
H
1F6 (DH)
H
1F5 (CH)
H
1F4 (CL)
H
1F3 (SN)
H
1F2 (SC)
H
1F1 (FR)
H
At command completion (I/O registers contents to be read)
1F7 (ST)
H
1F6 (DH)
H
1F5 (CH)
H
1F4 (CL)
H
1F3 (SN)
H
1F2 (SC)
H
1F1 (ER)
H
The host sets X'03' to the Features register. By issuing this command with setting a value to
the Sector Count register, the transfer mode can be selected. Upper 5 bits of the Sector Count
register defines the transfer type and lower 3 bits specifies the binary mode value.
However, the IDD can operate with the PIO transfer mode 4 and multiword DMA transfer
mode 2 regardless of reception of the SET FEATURES command for transfer mode setting.
The IDD supports following values in the Sector Count register value. If other value than
below is specified, an ABORTED COMMAND error is posted.
PIO default transfer mode
PIO flow control transfer mode X
Multiword DMA transfer mode X
Ultra DMA transfer mode X
5 - 36
1 1 1 0
DV
xx
xx
xx
xx or transfer mode
[See Table 5.6]
Status information
DV
xx
xx
xx
xx
Error information
00000 000 (X'00')
00001 000 (X'08': Mode 0)
00001 001 (X'09': Mode 1)
00001 010 (X'0A': Mode 2)
00001 011 (X'0B': Mode 3)
00001 100 (X'0C': Mode 4)
00100 000 (X'20': Mode 0)
00100 001 (X'21': Mode 1)
00100 010 (X'22': Mode 2)
01000 000 (X'40': Mode 0)
01000 001 (X'41': Mode 1)
01000 010 (X'42': Mode 2)
01000 011 (X'43': Mode 3)
01000 100 (X'44': Mode 4)
C141-E090-01EN
1 1 1 1
xx
xx