Gigabyte GA-H67MA-UD2H-B3 User Manual page 25

Lga1155 socket motherboard for intel core i7 processors/intel core i5 processors/intel core i3 processors/intel pentium processors/intel celeron processors
Table of Contents

Advertisement

6) SATA3_0/1 (SATA 6Gb/s Connectors, Controlled by H67)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The SATA3_0 and SATA3_1
connectors support RAID 0 and RAID 1. RAID 5 and RAID 10 can be implemented on the two con-
nectors with the SATA2_2/3/4 and eSATA connectors
Drive(s)," for instructions on configuring a RAID array.
7) SATA2_2/3/4 (SATA 3Gb/s Connectors, Controlled by H67 Chipset)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s stan-
dard. Each SATA connector supports a single SATA device. The H67 Chipset supports RAID 0,
RAID 1, RAID 5, and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on
configuring a RAID array.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are to be used, the total number of hard drives must be an even number.
• A RAID 5 configuration requires at least three hard drives. (The total number of hard drives
does not have to be an even number.)
• A RAID 10 configuration requires four hard drives.
(Note)
When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the system
performance of the RAID set may vary depending on the devices being connected.
. Refer to Chapter 5, "Configuring SATA Hard
(Note)
1
SATA3_0
SATA2_2
7
SATA2_3
1
SATA2_4
7
- 25 -
DEBUG
DEBUG
PORT
PORT
Pin No.
Definition
1
GND
2
TXP
7
3
TXN
SATA3_1
4
GND
5
RXN
6
RXP
7
GND
DEBUG
DEBUG
PORT
PORT
DEBUG
PORT
Pin No.
Definition
1
GND
2
TXP
3
TXN
4
GND
1
5
RXN
6
RXP
7
GND
Please connect the L-shaped end of the
SATA cable to your SATA hard drive.
Hardware Installation

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents