Back to Contents Page
Status-Light Board
Alienware® M14x Service Manual
Removing the Status-Light Board
Replacing the Status-Light Board
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
Removing the Status-Light Board
1. Follow the instructions in
Before You
2. Remove the base cover (see
3. Remove the battery pack (see
4. Remove the center-control cover (see
5. Remove the keyboard (see
6. Remove the palm-rest assembly (see
7. Turn the palm-rest assembly over.
8. Note the routing of status-light board cable and remove the cable from the routing guides.
1
status-light board cable
9. Remove the screw that secures the status-light board to the palm-rest assembly.
10. Lift the status-light board along with its cable away from the palm-rest assembly.
Begin.
Removing the Base
Cover).
Removing the Battery
Pack).
Removing the Center-Control
Removing the
Keyboard).
Removing the Palm-Rest
Removing the Battery
Cover).
Assembly).
Pack) before working inside the