Input Panels; Control Codes; Cable Connection - NEC V801 Installation Manual

V801 Installation Guide
80" LCD Display
Input Panel:
Bottom
Side (Rotated)

Control Codes:

NOTE: Contact your NEC rep for codes not listed.
NOTE: Use a cross/reverse/null modem cable.

Cable Connection

Communication Protocol:
Interface: RS-232C
Communication: Asynchronous
Baud Rate: 9600 bps
Data Length: 8 bits
NOTE:

If so desired, jumper "Request to send" and "Clear to Send" together on both ends of the cable to simplify cable connection. These
connections are not required. The only connections required are pins 2 (RxD), 3 (TxD) and 5 (GND).
www.necdisplay.com
Parity: None
Stop Bit: 1 bit
Communication Code: Hex
PC Control Connector (D-Sub 9Pin)
NEC Display Solutions of America, Inc.
V801
Rev 1.0
Page 8 of 8