Table of Contents
Advertisement
2.
Make sure the cables are secured in the wireways in the bottom of the
cordless base and that the base sits flat on a horizontal surface.
3.
The scanner beeps.
4.
Verify the scanner or cordless base operation by scanning a bar code
from the
Sample Symbols
The unit defaults to a USB PC Keyboard. Refer to
terminal settings.
For additional USB programming and technical information, refer to "USB
Application Note," available at
Connecting with Keyboard Wedge
A scanner or cordless base can be connected between the keyboard and
PC as a "keyboard wedge," plugged into the serial port, or connected to a
portable data terminal in wand emulation or non decoded output mode.
The following is an example of a keyboard wedge connection:
1.
Turn off power and disconnect the keyboard cable from the back of the
terminal/computer.
2.
Connect the appropriate interface cable to the device and to the
terminal/computer.
Corded Scanner
Keyboard Wedge
Connection:
in the back of this manual.
www.honeywellaidc.com.
page 2-4
for other USB
1 - 3
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
