Quick Power On - Panasonic HDCTM300 - HD SD CAMCORDER Operating Instructions Manual

3
Open the LCD monitor or extend
the viewfinder.
HDC-TM300
HDC-HS300
The status indicator A lights red and the unit is
put into recording pause.
≥ Quick Start Standby Mode is canceled if
jabout 5 minutes have elapsed
jmode is set to
junit is turned off
≥ Time for Quick Start will be more than 0.6
seconds slower when the digital cinema is
used.
≥ Depending on the recording conditions, time
for Quick Start may be more than 0.6 seconds
slower in Still Picture Recording Mode.
≥ It may take some time for Automatic White
Balance to adjust.
≥ In the Quick Start Mode, the zoom
magnification becomes 1k.
≥ If [ECONOMY] (l 36) is set to [5 MINUTES]
and the unit automatically goes into Quick Start
Standby Mode, close the LCD monitor and
then open it again.
≥ Quick Start Standby Mode cannot be released
by the remote control. Turn the mode to OFF
when powering off.
50
VQT1Z09

Quick power on

(Only when recording to an SD card or built-
in memory)
The unit is put into recording pause approx.
1.9 seconds when the mode is set to
from OFF.
≥ Start time will not shorten if there is no SD card
inserted.
Start time will be shorten if the [Built-in
Memory] is selected in the [MEDIA SELECT],
even if there is no SD card inserted.
¬ Change the mode to
1
Select SD card as a media to
record from the menu. (l 33)
[MEDIA SELECT] # [SD CARD]
2
Select the menu. (l 33)
[SETUP] # [QUICK POWER ON] # [ON]
≥ This function's default setting is [ON].
≥ Depending on the recording conditions, start
time may be longer than 1.9 seconds in Still
Picture Recording Mode.
≥ In the Quick Power on Mode, the zoom
magnification becomes 1k.
or
or .