Snmp Configuration; Cli Credentials - Dell Active Fabric Manager Deployment Manual

Dell fabric manager deployment guide 1.0.0
Hide thumbs Also See for Active Fabric Manager:
Table of Contents

Advertisement

1.
Navigate to the Administration > Settings screen.
2.
In the Syslog IP Addresses area, click Edit.
The Syslog IP Address screen displays.
3.
In the Sylog IP Addresses fields, enter the IP address of the syslog server.
4.
Click OK.

SNMP Configuration

Configure SNMP so that the DFM can perform SNMP queries on the switches in the distributed core. The values you
enter in the SNMP configuration are also used for configuring the switches during the build phase and for monitoring
during the run phase.
To configure SNMP:
1.
Navigate to the Administration > Settings screen.
2.
In the SNMP Configuration area, click Edit.
The Configuration SNMP window display:
3.
In the Read Community String field, enter the read community string. For example, "public".
4.
In the Write Community String field, enter the write community string. For example, "private".
5.
In the Port field, enter the SNMP port number of the switches. The port number is typically 161.
6.
In the Trap Host field, specify the IP address of the DFM Dell Fabric Manager
7.
Click OK.

CLI Credentials

To provision the distributed core, enter the FTOS CLI user's credential and enable the configuration credential for all the
switches in the distributed core. This option allows you to remotely make configuration changes to the switches in the
distributed core.
To configure the CLI credentials and enable the configuration credential for all the switches in the distributed core:
1.
Navigate to the Administration > Settings screen.
2.
In the CLI Credentials area, click the Edit button.
The CLI Credentials screen displays.
3.
In the Protocol pull-down menu, select one of the following options:
a) Telnet
b) SSHv2
c) Telnet & SSHv2
4.
In the User Name field, enter the user name.
5.
In the Password field, enter the password.
6.
In the Confirm Password field, confirm the password.
The privilege level is a read-only field and is set at 15.
7.
In the Enable Password field, enter a password for the privilege level.
8.
In the Confirm Enable Password field, confirm the enabled password for the privilege level.
9.
Click OK.
60

Advertisement

Table of Contents
loading

Table of Contents