Control Codes; Cable Connection - NEC NP-PH1400U Installation Manual

PH1000U/PH1400U Installation Guide
Desktop and Ceiling Mount
PC Control Codes
Function
POWER ON
POWER OFF
INPUT SELECT COMPUTER 1
INPUT SELECT COMPUTER 2
INPUT SELECT COMPUTER 3
INPUT SELECT HDMI
INPUT SELECT DisplayPort
INPUT SELECT VIDEO
INPUT SELECT S-VIDEO
INPUT SELECT VIEWER
INPUT SELECT NETWORK
PICTURE MUTE ON
PICTURE MUTE OFF

Cable Connection

Communication Protocol:
38400 bps (for cable lengths longer than 20', it is recommended changing to 9600 bps in setup menu)
Baud Rate:
Data Length: 8 bits
Parity: No Parity
Stop Bit: One bit
X on/off: None
Communications: Full duplex
PC Control Connector (D-Sub 9P)
Note 1 : Pins 1, 4, 6, and 9 are used inside the projector.
Note 2: For long cable runs it is recommended to set communication speed within the projector to 9600 bps.
Note 3: Jumper "Request to Send" and "Clear to Send" together on both ends of the cable to simplify cable connection.
www.necdisplay.com
Code Data
02H 00H 00H 00H
02H 01H 00H 00H
02H 03H 00H 00H
02H 03H 00H 00H
02H 03H 00H 00H
02H 03H 00H 00H
02H 03H 00H 00H
02H 03H 00H 00H
02H 03H 00H 00H
02H 03H 00H 00H
02H 03H 00H 00H
02H 10H 00H 00H
02H 11H 00H 00H
PH1000U/PH1400U
NEC Display Solutions of America, Inc.
00H 02H
00H 03H
02H 01H 01H 09H
02H 01H 02H 0AH
02H 01H 03H 0BH
02H 01H 1AH 22H
02H 01H 1BH 23H
02H 01H 06H 0EH
02H 01H 0BH 13H
02H 01H 1FH 27H
02H 01H 20H 28H
00H 12H
00H 13H
Rev 1.1
Page 14 of 14