Download  Print this page

The Printer Stops During A Print Job - Canon imagePROGRAF iPF6400 Basic Manual

Large-format printers.
Hide thumbs

Advertisement

An error message is shown on the Display Screen

The printer stops during a print job

The printer stops during a print job
An error message is shown on the Display Screen ....................................................................................... 100
The printer ejects blank, unprinted paper ......................................................................................................... 100
An error message is shown on the Display Screen
An error message is shown on the Display Screen
An error message is displayed during printing.
The last portion of roll paper was used during a print job, and paper
could not be advanced because the trailing edge is taped to the roll.
The printer ejects blank, unprinted paper
The printer ejects blank, unprinted paper
Cause
The leading edge of the roll paper was
cut to straighten it.
The Printhead nozzles are clogged.
A print job was received from an in-
compatible printer driver.
The printer is damaged.
100
Cause
The leading edge of rolls may be cut to straighten it if Trim Edge First is set to a value other
than Off in the Control Panel menu.
(See "Cutting the Leading Edge of Roll Paper Automatically.")
Print a test pattern to check the nozzles and make sure the Printhead is in good condition for
printing.
(See "Checking for Nozzle Clogging.")
Use the correct imagePROGRAF printer driver for the printer and try printing again.
Contact your Canon dealer for assistance.
Corrective Action
Check the error message and take action as necessary.
(See "Error Messages.")
→P.139
Remove the used roll and insert a new roll.
(See "Removing the Roll from the Printer.")
(See "Removing Rolls From the Roll Holder.")
(See "Loading and Printing on Rolls.")
Corrective Action
→User's Guide
→User's Guide
iPF6400
→P.14
→User's Guide
→User's Guide
Basic Guide

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: