Network Command Usage; Network --Show; Network --Restart; Network --Setdhcp - Dell PowerVault Storage Area Network Reference Manual

• Ping a destination host
• Perform basic troubleshooting
• Configure TCP packet filter operations based on port type, packet size, file size, and host
• Test network performance between any designated client and server on the network

Network Command Usage

This topic introduces the network command usage:
•

network --show

•

network --restart

•

network --setdhcp

• network --setstatic_ip [options]
• network --setdns [options]
• network --setbonding [options]
• network --nslookup [options]
• network --traceroute [options]
• network --ping [options]
• network --troubleshoot [options]
• network --tcpdump [options]
• network --iperf_client [options]
• network --iperf_server [options]
• network --help
NOTE: If you specify a command without supplying the expected value or option, you will be prompted to provide
the correct value or option.
network --show
Description
Displays the current networking configuration for a DR Series system.
Syntax
network --show
Result
Device
Boot protocol
IP Addr
Netmask
Gateway
MAC Addr
MTU
Bonding options
Slave Interfaces
eth0 MAC
eth0 Max Speed
eth0 Speed
eth0 Duplex
eth1 MAC
eth1 Max Speed
: dhcp
: 10.20.24.55
: 255.255.252.0
: 10.20.32.13
: 78:2B:CB:47:D0:08
: "mode=balance-alb miimon=100 xmit_hash_policy=2"
: eth0,eth1,eth2,eth3
: 78:2B:CB:47:D0:08
: 1000baseT/Full
: 1000Mb/s
: Full
: 00:50:56:93:5A:02
: 1000baseT/Full
: bond0
: 1500
35