Loading The Bypass Tray With Paper - Sharp AJ-2105 Operation Manual

LOADING THE BYPASS TRAY WITH PAPER

If you wish to print on banner paper or another paper type not loaded into the main paper
tray, use the bypass feed. Only one sheet of paper (or up to 5 sheets of banner paper) can
be placed in the bypass tray at a time.
Open the bypass tray located on the rear of the printer.
1
Load the paper print side up.
2
Align the paper with the right side of the bypass tray and press the paper button.
The paper will be fed slightly into the printer.
When loading an envelope
Open the bypass tray until it reaches position 2 (the tray has two stop positions),
set the paper knob to the "Thick Paper (
Load the envelope face up with the flap to the right, and position against the right
edge of the tray as shown bellow. Refer to "Notes for loading envelopes" on page 17.
When loading banner paper
Open the bypass tray until it reaches position 2, and set the paper along the right
side edge of the tray.
Maximum 5 sheets of banner paper can be used.
When printing onto banner paper, ensure to use an application software
supporting banner paper.
The paper knob should always be set to the "Normal Paper (
while printing on thick paper or envelopes.
)" setting.
Position 1
Position 2
)" setting except
19