Network Connection - Samsung 7 series User Manual

Network Connection

¦
You can set up the Internet Protocol so that you can communicate with various connected networks.
Network Connection - Cable
❑
LAN Connection for a DHCP Environment
■
The procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described below. Since an IP
address, subnet mask, gateway, and DNS are automatically allocated when DHCP is selected, you do not have to enter them
manually.
1. Connect the LAN port on the rear panel of the TV and the external modem with a LAN Cable.
2. Connect the Modem port on the wall and the external modem with a Modem Cable.
The Modem Port on the Wall
You can connect the LAN via a Sharer (router).
The Modem Port on the Wall
You can connect the LAN port and the TV directly depending on your network status.
The LAN Port on the Wall
The terminals (the position of the port and the type) of the external device may differ depending on the manufacturer.
N
If the IP address allocation by the DHCP server has failed, turn the external modem off, turn it on again after at least 10
N
seconds and then try again.
For the connections between the external modem and the Sharer (Router), refer to the owner's manual of the corresponding
N
product.
You can connect the TV to the LAN directly without connecting it through a Sharer (Router)
N
You cannot use a manual-connection-type ADSL modem because it does not support DHCP. You have to use an automatic-
N
connection-type ADSL modem.
External Modem
(ADSL / VDSL / Cable TV)
2 Modem Cable
External Modem
(ADSL / VDSL / Cable TV)
Modem Cable
English - 24
1 LAN Cable
IP Sharer
LAN Cable
LAN Cable
TV Rear Panel
TV Rear Panel
LAN Cable
TV Rear Panel