Samsung 6 series User Manual page 37

•
Ad-hoc: You can connect to a mobile device without an access point through the 'Samsung Wireless LAN Adapter' by
using a peer to peer network.
How to connect to new Ad-hoc
1. Choose Select a network, then a device list is displayed.
2. While in the device list, press the Blue button on the remote or select Ad-
hoc.
The message The existing network system may have limited
N
functionality. Do you want to change the network connection? is
displayed.
. Input the generated Network Name(SSID) and Security Key into the
device you want to connect.
How to connect an existing Ad-hoc device
1. Choose Select a network, the device list is displayed.
2. Select the device you want in the Device list.
. If security key was applied, input the security key again.
If network doesn't operate normally, please check the Network
N
Name(SSID) and Security Key again. If the Security Key is incorrect,
it may be the reason for the malfunction.
Wireless Network Setup-Auto Setup
If you want to connect AP, AP should support DHCP. Only devices which support Ad-hoc mode
can be connected without DHCP.
1. Set Network Type to Wireless.
2. Select Wireless Network Setup.
. Set Internet Protocol Setup to Auto Setup.
The Internet Protocol is set automatically.
N
4. Select a network through Select a network.
. Select Network Test to check the network connectivity.
Wireless Network Setup-Manual Setup
1. Set Network Type to Wireless.
2. Select Wireless Network Setup.
. Set Internet Protocol Setup to Manual Setup.
4. Set up IP Address, Subnet Mask, Gateway and DNS Server.
Press the number buttons on the remote control when you set the Network manually.
N
. Select a network through Select a network.
6. Select Network Test to check the network connectivity.
English - 
The existing network system may have limited
functionality. Do you want to change the network
connection?
Yes No
Wireless Network Setup
Internet Protocol Setup : Auto Setup ▶
Network Test
Select a network : AP1
IP Address :
Subnet Mask :
Gateway :
DNS Server :
U Move E Enter R Return
Wireless Network Setup
Internet Protocol Setup : Manual Setup ▶
Network Test
Select a network : AP1
IP Address : 0 0 0 0
Subnet Mask : 0 0 0 0
Gateway : 0 0 0 0
DNS Server : 0 0 0 0
U Move E Enter R Return