Table of Contents
Advertisement
ESCP Switch
Important
• Each of the [Text], [Minimum Text], [Page Length] and [1 inch Skip] settings is not reflected when
extended commands arrive as these features select defaults.
Text
Sets the print quality mode of the text to [Text High Dens.] (default) or [Draft].
Note
• Actual printing is not changed by changing this setting.
• This setting influences the text definition selection command.
Minimum Text
Text can be printed in reduced size when printing 1-byte type alphanumerics.
[Off] (default)
Alphanumerics are printed at actual size.
[On]
Alphanumerics are printed reduced in size.
Character Code
Sets the type of the character code to [Graphic] (default) or [Slant].
Page Length
Sets [11 inches] (default) or [12 inches] for the length (print area) of one page.
1 inch Skip
Sets whether or not to leave one inch between pages.
[Off] (default)
Does not leave a one-inch gap between pages.
[On]
Leaves a one-inch gap between pages. When you set to leave a one-inch gap between
pages, you can print to leave a one-inch gap between pages even with cut sheet paper just
like skipping of perforations when continuous roll paper is used.
Important
• This is executed when use of the cut sheet feeder is set to [Off] at [Page Position].
Feed Position
Sets the printing start position to either of [8.5 mm] (or [0.3"]) (default) or [22 mm] (or [0.9"])
from the top edge of the paper.
CR Functions
Sets the operation when the CR command is received.
[CR] (default)
Returns the print head only.
[CR/LF]
Returns the print head and performs a line feed.
0 Style
Sets the 0 character style.
[0] (default)
The normal "0" character is set.
[ ]
The slashed "0" character is set.
2.2 ESC/P Mode Menu Settings
19
Advertisement
Table of Contents
