Show User Name Display
System Admin > Change Password
Specifies whether the projector can be turned on via wired LAN while the projector
is in standby (projector off with power being supplied).
Enable: Power on enabled.
Disable: Power on disabled (initial default).
Performing an "Initialize Network Settings" operation or "Restore All
Defaults" operation with the setup menu will cause this setting to change to
"Disable". If you are operating the projector using a wired LAN setting, be
sure to change this setting back to "Enable" after initialization. The "Remote
on" setting can also be changed on the projector using the setup menu. For
full details, see "Wired LAN Settings Main Menu (USB Port Models Only)" in
the "User's Guide" (UsersGuide_English.pdf).
Enables and disables PJLink connection authentication.
Enable: PJLink connection authentication enabled (initial default).
Disable: PJLink connection authentication disabled.
Specifies whether the computer's user name should appear on the projection
screen when projection starts from a computer connected to the projector via
Initial Default: On (User name displayed.)
For input of the new password when logging in to the System Admin page.
Initial Default: admin