Connecting A Computer - Connecting A Computer To The Back Of The Television - Toshiba WL66/67 Owner's Manual

Before connecting any external equipment, turn off all main power switches. If there is no switch
remove the mains plug from the wall socket.
Computer
Connect the PC cable from the computer to the PC
terminal on the back of the television.
Connect the audio cable to the PC/HDMI1 Audio
socket on the back of the television. Select PC from the
PC/HDMI1 audio options in the AV connection
menu located in the SET UP menu.
Press the B to select PC mode.
The following signals can be displayed:
VGA: 640 x 480/60 Hz (VESA)
SVGA: 800 x 600/60 Hz (VESA)
XGA: 1024 x 768/60 Hz (VESA)
SXGA: 1280 x 1024/60 Hz (VESA)
IMPORTANT NOTE: SXGA will display but it will
not be to VESA standard.
PLEASE NOTE:
Some PC models cannot be connected to this
television.
An adaptor is not needed for computers with a DOS/V
compatible mini D-sub 15 pin terminal.
A band may appear at the edges of the screen or parts
of the picture may be obscured. This is due to scaling
of the picture by the set, it is not a malfunction.
Connecting a computer
the back of your television
Audio cable for PC to
television connection
(not supplied)
Conversion adaptor if required (not supplied)
When PC input mode is selected some of the
television's features will be unavailable e.g. Manual
setting in the SET UP menu, Colour, Tint, DNR and
Black Stretch in the Picture settings menu.
Signal information for Mini D-sub 15 pin connector
Pin assignment
for RGB/PC
terminal
Pin. No. Signal name
1
2
3
4 NC (not connected)
5 NC
6 Ground
7 Ground
8 Ground
7
Mini D-sub
15 pin connector
RGB PC cable
(not supplied)
Pin No. Signal name
R 9
G 10 Ground
B 11
12
13 H-sync
14 V-sync
15
NC
NC
NC
NC