Table of Contents
Advertisement
Door Removal and Reversal Instructions
DOOR REMOVAL INSTRUCTIONS:
If your refrigerator will not fit through an entrance area, you can reduce its size
Top Hinge
by removing the doors. Check first by measuring the entrance.
Cover
Top Hinge
1. Disconnect electrical supply.
2. Remove toe grille (see page 4 to learn how).
To remove freezer door:
1. Remove top hinge cover and screws.
2. Trace around the hinge with a soft lead pencil. This makes reinstallation
Cable
3. Remove top hinge and lift door off bottom hinge pin.
4. Reverse this procedure to reinstall freezer door.
To remove refrigerator door:
1. Place wood block under door to support its weight.
Bottom
2. Detach the multi-wire cable connector located below the door.
Hinge
Water Tube
3. Detach the water tube from the connector located below the door. The
Wood Block
4. Remove the bottom hinge screws and hinge, holding the door as its
5. Lay the door on its side to avoid damage to the water tube and cable.
6. Remove the center hinge screws and hinge. Ensure plastic washer
7. Reverse this procedure to reinstall refrigerator door.
Shim
When both doors have been reinstalled, connect water line by inserting tube
Pin
and pushing until mark touches face of fitting. Connect cable, replace toe grille,
and plug in electrical power cord.
Center
Hinge
IMPORTANT: Before you begin, turn the refrigerator temperature control
to "0" and remove the electrical power cord from the wall outlet. Remove
any food from door shelves.
easier.
Grasp both sides of the connector firmly and pull apart.
connector releases when you press its outer sleeve inward.
NOTE: If refrigerator has been used, have a container ready to catch
excess water from tube.
weight rests on the wood block.
stays on hinge pin.
6
Advertisement
Table of Contents
