Chapter 5 Appendix; Configuring Sata Hard Drive(S); Configuring The Onboard Sata Controller - Gigabyte GA-M61PME-S2 User Manual

Am2 socket motherboard for amd athlon 64 fx processor/ amd athlon 64 x2 dual-core processor/ amd athlon 64 processor/amd sempron processor
Hide thumbs Also See for GA-M61PME-S2:
Table of Contents

Advertisement

Chapter 5 Appendix

5-1

Configuring SATA Hard Drive(s)

To configure SATA hard drive(s), follow the steps below:
A. Install SATA hard drive(s) in your computer.
B. Configure SATA controller mode in BIOS Setup.
C . Configure a RAID array in RAID BIOS.
D. Make a floppy disk containing the SATA RAID driver.
E. Install the SATA RAID driver
Before you begin
Please prepare:
• At least two SATA hard drives (to ensure optimal performance, it is recommended that you use
two hard drives with identical model and capacity). If you do not want to create RAID, you may
prepare only one hard drive.
• An empty formatted floppy disk.
• Windows Vista/XP/2000 setup disk.
• Motherboard driver disk.

5-1-1 Configuring the Onboard SATA Controller

A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to an
available SATA port on the motherboard. Then connect the power connector from your power supply
to the hard drive.
(Note) Skip this step if you do not want to create RAID array on the SATA controller.
(Note)
and operating system.
(Note)
- 65 -
(Note)
Appendix

Advertisement

Table of Contents
loading

Table of Contents