Table of Contents
Advertisement
BEFORE SETTING OVEN CONTROLS
Oven vent location
The oven vent is located under the left rear surface
element (See Fig. 1). When the oven is on, warm air
passes through the vent. This venting is necessary for
proper air circulation in the oven and good baking results.
Do not block the oven vent.
oven vent located
under left rear element
Types of oven racks
Your range may be equipped with one or more of the oven
rack styles shown.
flat
oven rack
The flat oven rack or flat handle oven rack (some
models) may be used for most cooking needs.
The offset oven rack (some models) is designed to place
the base of the rack about 1/2 of a rack position lower than
normal. This rack design provides several additional
possible locations between the standard positions.
6
Fig. 1
flat handle
oven rack
offset
oven rack
Removing, replacing & arranging racks
To remove - pull the rack forward until it stops. Lift up
front of rack and slide out.
To replace - fit the rack onto the guides on the oven walls.
Tilt the front of the rack upward and slide the rack back into
place.
Arranging - always arrange the oven racks when the oven
is cool (prior to operating the oven).
CAUTION
Always use oven mitts when using the oven. When
using the appliance, oven racks and cooktop will become
very hot which can cause burns.
Recommended rack positions by food type
Food type
Broiling meats
Cookies, cakes, pies, biscuits & muffins
Frozen pies, angel food cake, yeast, bread
and casseroles
Small cuts of meat or poultry
Turkey, roast or ham
Air circulation in the oven
For best baking results allow 2-4" (5-10 cm) around the
cookware for proper air circulation and be sure pans and
cookware do not touch each other, the oven door, sides or
back of the oven cavity. Hot air must be able to circulate
around the pans and cookware in the oven for even heat to
reach around the food.
Fig. 2
Position
See broil
2 or 3
1 or 2
1 or 2
1
Advertisement
Table of Contents
