Frigidaire F30WC Series User Manual

Frigidaire F30WC Series User Manual

4-way convertible range hood

Advertisement

Quick Links

F30WC, F36WC, & F42WC SERIES
4-WAY CONVERTIBLE RANGE HOOD
READ AND SAVE THESE INSTRUCTIONS
!
INTENDED FOR DOMESTIC COOKING ONLY
IMPORTANT
For Non-ducted (Ductfree) Installation:
a) Purchase non-ducted filter separately.
b) Remove and discard damper/duct connector and louver cover
(See Step 4) in "Prepare the Hood, " Page 2.
c) Follow all steps except steps inside dotted lines.
For Ducted Installation:
Follow all steps, including steps inside dotted lines.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-
JURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufac-
turer. If you have questions, contact the manufacturer at
the address or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at ser-
vice panel and lock the service disconnecting means to
prevent power from being switched on accidentally. When
the service disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to the
service panel.
3. Installation work and electrical wiring must be done by a
qualified person(s) in accordance with all applicable codes
and standards, including fire-rated construction codes and
standards.
4. Sufficient air is needed for proper combustion and exhaust-
ing of gases through the flue (chimney) of fuel burning equip-
ment to prevent backdrafting. Follow the heating equipment
manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code au-
thorities.
5. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. Do not use this unit with any solid-state speed control de-
vice.
8. To reduce the risk of fire, use only metal ductwork.
9. Use with approved cord-connection kit only.
10. This unit must be grounded.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
1. Never leave surface units unattended at high settings.
Boilovers cause smoking and greasy spillovers that may
ignite. Heat oils slowly on low or medium settings.
2. Always turn hood ON when cooking at high heat or when
cooking flaming foods.
3. Clean ventilation fans frequently. Grease should not be al-
lowed to accumulate on fan or filter.
4. Use proper pan size. Always use cookware appropriate for
the size of the surface element.
WARNING
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE
EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE
FOLLOWING:*
1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or
metal tray, then turn off the burner. BE CAREFUL TO PRE-
VENT BURNS. If the flames do not go out immediately, EVACU-
ATE AND CALL THE FIRE DEPARTMENT.
2. NEVER PICK UP A FLAMING PAN - You may be burned.
3. DO NOT USE WATER, including wet dishcloths or towels -
a violent steam explosion will result.
4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher and you
already know how to operate it.
B. The fire is small and contained in the area where it started.
C. The fire department is being called.
D. You can fight the fire with your back to an exit.
* Based on "Kitchen Fire Safety Tips" published by NFPA.
CAUTION
1. For general ventilating use only. Do not use to exhaust
hazardous or explosive materials and vapors.
2. To avoid motor bearing damage and noisy and/
or
unbalanced
construction dust, etc. off power unit.
3. Your hood motor has a thermal overload which will automatically
shut off the motor if it becomes overheated. The motor will
restart when it cools down. If the motor continues to shut off
and restart, have the hood serviced.
4. For best capture of cooking impurities, your range hood should
be mounted 18-24" above the cooking surface.
5. Please read specification label on product for further information
and requirements.
INSTALLER: Leave This Manual With
the Homeowner.
HOMEOWNER: Use and Care
Information on Page 5.
1
!
!
impellers,
keep
drywall
spray,

Advertisement

Table of Contents
loading

Summary of Contents for Frigidaire F30WC Series

  • Page 1 F30WC, F36WC, & F42WC SERIES 4-WAY CONVERTIBLE RANGE HOOD READ AND SAVE THESE INSTRUCTIONS INTENDED FOR DOMESTIC COOKING ONLY IMPORTANT For Non-ducted (Ductfree) Installation: a) Purchase non-ducted filter separately. b) Remove and discard damper/duct connector and louver cover (See Step 4) in “Prepare the Hood, ” Page 2.
  • Page 2: Materials Required

    TOOLS AND MATERIALS REQUIRED TOOLS ❏ Drill, electric or ratchet drive ❏ 1-1/4" Spade bit ❏ Common head and phillips head screwdriver ❏ Pliers ❏ Tape measure or ruler and pencil For Ducted Installations ONLY: ❏ Saber saw or drywall saw ❏...
  • Page 3: Preparing The Range Hood

    PREPARING THE RANGE HOOD 1. Unpack hood and check contents. You should receive: 1 - Aluminum Filter 1 - 3-1/4" x 10" Damper/Duct Connector (mounted inside of hood for shipping only) (Save screws for mounting.) 1 - 7” Round Duct Plate (mounted on top of hood) (not shown) (Save screws for mounting.) 2.
  • Page 4 INSTALLING THE DUCTWORK NOTE THESE INSTRUCTIONS WILL FOLLOW THE PLANS MADE ON PAGE 2. START AT THE EXTERIOR AND RUN THE DUCT BACK TO THE RANGE HOOD. FOR BEST PERFORMANCE OF YOUR RANGE HOOD, USE THE SHORTEST POSSIBLE DUCT RUN AND A MINI- MUM NUMBER OF ELBOWS.
  • Page 5: Installing The Range Hood

    INSTALLING THE RANGE HOOD 16.Bring electrical cable through access hole drilled in wall or bottom of cabinet. Provide 6" wire leads and install proper connector for type of cable being used. Remove lock nut from connector and let prepared cable project through cabi- net or wall opening so it is ready for installation into range hood.
  • Page 6: Service Parts

    SERVICE PARTS F30WC, F36WC, & F42WC SERIES RANGE HOOD KEY NO. Order service parts by “KEY NO.” * Standard Hardware. May be purchased locally. DESCRIPTION Outlet Box Cover #8 x 3/8 Sheet Metal Screw* Bulb Holder with Wires Light Lens Screw/Nut Kit (Includes 2 - #10-16 x .500 screws and 2 - #10-16 sheet metal nuts)
  • Page 8 Major Appliance Warranty Information Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used, and maintained in accordance with the provided instructions.

This manual is also suitable for:

F36wc seriesF42wc seriesF42wc19eF30wc19esF36wc19ebF36wc19ec ... Show all

Table of Contents