Download Print this page

Frigidaire FGEW2765K F Specification Sheet page 5

27" electric single wall ovens
Hide thumbs Also See for FGEW2765K F:


27" Combination Installation Specifications
Always consult local and national electric codes.
(Refer to product-specific electrical specifications on this page.)
Minimum 23-1/2" deep cutout dimension is critical for proper
combination installation, to ensure that each built-in product's
faceplate will fit flush against cabinet front.
Bases must be level and cabinet front must be square.
Minimum 4-1/2" required distance from bottom of Wall Oven cutout
to floor, 31" suggested.
Respect critical dimensions as noted for proper installation of
built-In products.
Minimum 21" clearance needed for Wall Oven door depth when open.
27" Built-In Microwave Specifications
For built-in installation, microwave MUST be installed with optional
27" Trim Kit which includes Bottom Duct Assembly – shipped in
separate box, ordered by individual part number.
Voltage Rating – 120V / 60 Hz / 15 or 20 Amps
Connected Load (kW Rating) @ 120 Volts = 1.7 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
Amps @ 120 Volts = 14.3 Amps
Full base of solid plywood or similar material required, capable of
supporting 100 Lbs.
Minimum 2-7/8" clearance required from bottom of Built-In Microwave
cutout to top edge of Wall Oven's faceplate, leaving a 2" visible gap
between both product faceplates.
Electrolux Major Appliances, North America
Electrolux Canada Corporation
250 Bobby Jones Expressway
5855 Terry Fox Way
Mississauga, ON L5V 3E4
© 2009 Electrolux Home Products, Inc.
27" Combination Installation
27" Electric Single Wall Oven Specifications
Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz
AC only electrical supply with ground required on separate circuit
fused on both sides of line.
For detailed electrical requirements, refer to model-specific product
page and installation guide on web.
Full base of solid plywood or similar material required, capable of
supporting 200 Lbs.
To adapt oven to fit cutout height greater than 28-1/8", add one
2"-wide wood shim of appropriate height to each side of opening
under oven side rails. Lifting oven will hide larger cutout opening
at top and oven's 1"-high bottom trim will hide shims at bottom.
(Standard 1"- High Bottom Trim included.)
Note: For planning purposes only. Refer to Product Installation Guide
on the web at for detailed instructions.
Martinez, GA 30907
Built-In Microwave / Single Wall Oven
Printed in the U.S.A.
subject to change.



Subscribe to Our Youtube Channel

This manual is also suitable for:

Gallery fgew2765kfFgew2765k wFgew2765k b