This document is intended for the use of Nokia's customers only for the purposes of the agreement under which the document is submitted, and no part of it may be reproduced or transmitted in any form or means without the prior written permission of Nokia.
Product Overview Product description The Nokia ET-adapter is a plug-and-play Ethernet interface adapter for Dynanet (DNT) modems. This Ethernet interface adapter can be installed to the adapter port of a DNT modem. Figure 1. ET adapter The main function of the ET-adapter is to bridge two LANs over the WAN.
Product description are fixed. There are three selectable Ethernet interface settings in E66210.33: 10BASE half and full duplex and 100BASE full duplex. The data path and main components of ET-adapter are described in the block diagram below. ET-Adapter 100 BASE-T...
Product Overview Table 1. E66210.33 bridging Link speed 10BASE 10BASE 100BASE Duplex status Half Full Full Closed pins LED 100 LED HD Installing E66210.32 Figure 7. Installing the adapter Switch off the modem power, plug the ET-adapter into the slot and tighten two screws.
Off Off Full LINK Figure 9. Front panel E66210.33 RX displays receive status. LED blinks every time when an Ethernet packet is received from the LAN. LINK displays link status. LED is lit when cable is connected to another Ethernet equipment and the link is up. Link status is also shown at the DNT modem: if the link is down there is no incoming signal alarm.