Table of Contents
Advertisement
Operating preset memory (PMEM)
Setting the operation items for when preset
memory is recalled (PRESET SCOPE)
You can select whether to recall all or only some of the settings
registered to preset memory.
Note
z This function is enabled when AW-HE50, AW-HE60, or
AW-HE120 is selected.
1 .
Press one of the camera selection buttons
[CAMERA SELECT/GROUP SELECT] to select the
remote camera to be operated .
2 .
Press the PMEM button to turn on its indicator .
3 .
Press the MEM SETTING button to turn on its indicator .
The setting of the selected remote camera is displayed.
SP E E D
SC O P E
4 .
Turn the F2 dial to select a setting for the "SCOPE" item
from MODE A to MODE C, and then press the F2 dial to
confirm the selection .
The setting of the remote camera is changed.
This is applied the next time the preset is recalled.
<SCOPE settings and recalled items>
Setting
Pan, tilt, zoom,
and focus
MODE A
√
MODE B
√
MODE C
√
Note
z MODE A to MODE C are not registered to the remote camera
preset memory or the unit. The settings become the common
settings for when preset memory is recalled, and the same
settings are applied regardless of which preset number is
selected.
(continued)
:
3 0
: M O D E A
Recalled item
White balance
Iris
adjustment
value
√
√
√
—
—
—
√: Recalled —: Not recalled
Registering the speed at which to move
to the position set in the preset memory
(PRESET SPEED)
The unit registers the speed (PRESET SPEED) at which to move to the
set position when preset memory is recalled to each preset number.
When a preset is recalled, the unit sets PRESET SPEED on the remote
camera and the remote camera moves to the preset position at the
speed set for PRESET SPEED.
Performing operation at a different speed for each preset memory
enables video to be played at a variety of speeds.
Notes
z The movement speed registered in the procedure below is
registered to the corresponding camera number, and is not
registered to the preset memory of the remote camera. Therefore,
if the preset memory is recalled from a controller other than this
unit on which the movement speed was registered, movement
will be at a different speed even in the case of the same preset
number.
z When the connection type or connection destination IP address
is changed with CTRL TYPE menu [36], AUTO IP menu [37], or
SWAP IP menu [38], PRESET SPEED set for the corresponding
camera number is initialized.
1 .
Press one of the camera selection buttons
[CAMERA SELECT/GROUP SELECT] to select the
remote camera to be operated .
2 .
Press the PMEM button to turn on its indicator .
3 .
Press the MEM STORE button to turn on its indicator .
4 .
Press the MEM SETTING button to turn on its indicator .
The setting of the selected remote camera is displayed.
SPEED
SCOPE
5 .
Turn the F1 dial to select the setting of the "SPEED"
item, and then press the F1 dial to confirm the selection .
The following shows the relationship between the set value and the
speed at which the remote camera moves to the set position when
preset memory is recalled.
1
30
Slow
Fast
6 .
Hold down a number button to specify the preset
number to register .
The current remote camera settings are registered to preset
memory, and PRESET SPEED is registered to the unit.
:
30
: MODE A
15
Advertisement
Table of Contents
