Connecting To Optional Equipment; Connections - Sanyo HV-DX1E Instruction Manual

Connections (Cont'd)

Connecting to Optional Equipment

Connecting to an amplifier equipped with two
channel analog stereo or Dolby Surround
Connect the Left and Right AUDIO OUT jacks on the
DVD+VCR to the audio left and right in jacks on your
amplifier, receiver or stereo system, using the supplied
audio cables (A2).
Connecting to an amplifier equipped with two
channel digital stereo (PCM) or to an Audio/
Video receiver equipped with a multi-channel
decoder (Dolby Digital™, MPEG 2 or DTS)
Connect the DVD+VCR's DIGITAL AUDIO OUT
1 1
jack (COAXIAL X) to the corresponding in jack on
your amplifier. Use an optional digital (coaxial X)
audio cable.
You will need to activate the DVD+VCR's digital
2 2
output. (See "Digital Audio Output" on page 19).
Digital Multi-channel sound
A digital multi-channel connection provides the best
sound quality. For this you need a multi-channel
Audio/Video receiver that supports one or more of the
audio formats supported by your DVD+VCR (MPEG 2,
Dolby Digital and DTS). Check the receiver manual and
the logos on the front of the receiver.
Warning:
Due to the DTS Licensing agreement, the digital output
will be in DTS digital out when DTS audio stream is
selected.
Notes
– If the audio format of the digital output does not match
the capabilities of your receiver, the receiver will
produce a strong, distorted sound or no sound at all.
– To see the audio format of the current DVD in the On-
Screen Display, press AUDIO.
Accessory Audio/Video (A/V) Connections to
DVD+VCR
Connect the AV INPUT jacks on the DVD+VCR to the
audio/video out jacks on your accessory component,
using the optional audio/video cables.
11