Gigaset SX763 User Manual page 58

Configuring Advanced Settings
ì
Enter the name of the connection given to you by your service provider in the
Access concentrator name field.
ì
Apply the default settings for the parameters IP address type, IP address, MTU,
Line mode, Encapsulation, QoS class and VPI / VCI unless your service provider has
provided you with other data. The default settings also depend on your choice of
country.
Note:
To configure the Internet connection successfully, you must enter the details
given by your provider in all fields.
ì
If you have connected an external modem and chosen the connection type
Ethernet, enter the values for VLAN tag for each connection type that you have
received from your Internet service provider.
The Line mode, Encapsulation, QoS class and VPI / VCI boxes are then deactivated.
ì
Specify how Internet sessions are to be established via Connection mode:
– Select Always on if the connection is to exist at all times when the Gigaset SX763
WLAN dsl is turned on.
Notes:
u
You must set up the Always on option if you wish to use Internet telephony.
Otherwise you can only use fixed network telephony via the Gigaset SX763
WLAN dsl.
u
If you are on a time-based tariff, this option can result in high connection
charges.
– Select Connect on demand if applications such as an Internet browser or an e-
mail program are to connect to the Internet automatically.
– In the Idle time before disconnect field, enter a period after which the Internet
connection is to end automatically if no data is transmitted (the default setting is
3 minutes).
This time setting only applies to the Connect on demand option.
– Select Connect manually if you always want to establish and end the Internet
connection manually. If you are on a time-based tariff this will save you high con-
nection charges.
Note:
If you select Connect on demand or Connect manually, you can establish or
end the Internet connection manually on the start screen for the configuration
program (page 35).
ì
Click Test Settings to check the settings.
An attempt is made to set up an Internet connection. The result is shown in a sepa-
rate window.
ì
Click the Close button, which is shown if the test was successful.
58