Toshiba Satellite U840 Series User Manual page 98

Problem
Monitor does not
turn on
No display
Display error occurs
LAN
Problem
Cannot access LAN
User's Manual
Procedure
After confirming that the monitor's power switch is
on, you should check the connections to make
sure that the power cord/adaptor is firmly
connected to the monitor and to a working power
outlet.
Try adjusting the contrast and brightness controls
on the external monitor.
Press the hot key in order to change the display
priority and ensure that it is not set for the internal
display only.
Check to see if the external monitor is connected.
When the external monitor is set as the primary
display device in extended desktop mode, it will not
display when the computer wakes up from Sleep
Mode if the external monitor has been
disconnected while in Sleep Mode.
To keep this from happening, do not disconnect
the external monitor while the computer is in Sleep
or Hibernation Mode.
Remember to turn off the computer before
disconnecting the external monitor.
When the display panel and an external monitor
are set to clone mode and they are turned off by
the timer, the display panel or the external monitor
may not display when turned on again.
If this occurs, press the hot key to re-set the
display panel and external monitor to clone mode.
Check that the cable connecting the external
monitor to the computer is firmly attached.
If you are still unable to resolve the problem,
contact TOSHIBA Support.
Procedure
Check for a firm cable connection between the
LAN jack and the LAN hub.
Satellite U840/U800 Series
6-13