Ipp Print In A Windows Operating System Environment; Novell Print In A Netware Environment - Toshiba e-STUDIO5520c Troubleshooting Manual
Hide thumbs
Also See for e-STUDIO5520c:
- Copying manual (210 pages) ,
- Service handbook (648 pages) ,
- Imaging manual (288 pages)
Table of Contents
Advertisement
6.TROUBLESHOOTING FOR NETWORK CONNECTIONS
IPP print in a Windows operating system environment
No. Check...
1
Are the IP address properties correctly set?
2
Is the HTTP server on the equipment enabled?
3
Is the IPP print correctly set?
4
Were the proper printer drivers installed?
5
Is the IPP port configured with the correct URL?
6
Can you print to the equipment?
Novell print in a NetWare environment
No. Check...
1
Are the IPX/SPX protocols enabled? Is the correct
frame type selected?
2
If applicable, did you successfully set up queue-
based print?
3
Did you configure the equipment for a NetWare
connection?
4
Did you configure the equipment for Novell print
service?
5
Were the proper printer drivers installed?
6
Is the IPP port configured with the correct URL?
7
Can you see the equipment in Windows Network
Neighborhood?
8
Can you print to the equipment?
6 TROUBLESHOOTING FOR NETWORK CONNECTIONS
Yes
No
Corrective Action
Next Step
Set up the IP address correctly.
Enable the HTTP server in the HTTP Network
Next Step
Service.
Next Step
Set up the IPP print service correctly.
Refer to the Software Installation Guide to
Next Step
install the proper printer drivers.
Refer to the Software Installation Guide to
Next Step
configure the proper port.
See the following section to fix the problem:
End
P.68 "Cannot print with the equipment
(network connection problems)"
Yes
No
Corrective Action
Set up the IPX/SPX correctly.
Next Step
Set up the NetWare server properly.
Next Step
Set up the NetWare network settings correctly.
Next Step
Set up the Novell print service correctly.
Next Step
Refer to the Software Installation Guide to
Next Step
install the proper printer drivers.
Refer to the Software Installation Guide to
Next Step
configure the proper port.
Check that the SMB protocol is enabled in the
Next Step
client computers.
See the following section to fix the problem.
End
P.68 "Cannot print with the equipment
(network connection problems)"
Printing Problems (Network Related)
83
Advertisement
Table of Contents
Troubleshooting
