Cleaning - Frigidaire 154575701 Use And Care Manual

Care and Cleaning
Property Damage Hazard
Freezing temperatures may cause water lines
to rupture. Be sure all supply lines to and
circulating lines within dishwasher are
protected.
Failure to do so could result in property
damage.
Winterizing
A dishwasher left in an unheated place should be
protected from freezing. Have a qualified person
do the following:
To Disconnect Service:
1. Turn off electrical power to the dishwasher at
the supply source by removing fuses or
tripping circuit breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect
water line from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain
water into pan.
Note: See Installation Instructions for more
details.
To Restore Service:
1. Reconnect the water, drain, and electrical
power supply.
2. Turn on water and electrical power supply.
3. Fill both detergent cups and run dishwasher
through a POTS & PANS cycle.
4. Check connections to make sure they do not
leak.
Note: See Installation Instructions for more
details.
(continued)
Cleaning the Spray Arm
The spray arm may need to be cleaned to insure
that there are no clogs to the spray arm jets and
bearings due to hard water chemicals.
To remove spray arm simply hold the spray arm in
place and turn the retaining nut clockwise and
pull up on the spray arm lifting off the shaft.
To clean the spray arm use warm soapy water
using a soft brush to clean the jets and bearings.
To replace the spray arm simply set the spray arm
on the shaft, take the retaining nut and turn it
counter clockwise till it has locked into place.
14