Paper Does Not Feed Properly; Envelopes *3 - Canon MP630 SERIES On-Screen Manual

Paper Does Not Feed Properly

>
Advanced Guide Troubleshooting
Paper Does Not Feed Properly
Check 1: Make sure of the following when you load paper.
When loading two or more sheets of paper, align the edges of the sheets before loading.
When loading two or more sheets of paper, make sure that the paper stack does not exceed the
paper support load limit.
However, proper feeding of paper may not be possible at this maximum capacity depending on
the type of paper or environmental conditions (either very high or low temperature and humidity).
In such cases, reduce the sheets of paper you load at a time to less than half of the paper
support load limit.
Always load the paper in portrait orientation, either in the Rear Tray or the Cassette, regardless
of the printing orientation.
When you load the paper on the Rear Tray, load the paper with the print side facing UP and
slide the Paper Guides to align with the both sides of the paper.
When loading paper in the Cassette, load the paper with the print side facing DOWN. Align the
right edge of the paper stack against the right edge of the Cassette and slide the Paper Guides
against the left and bottom edges of the stack.
Loading Paper / Originals
Check 2: Check to see if the paper you are printing on is not too thick or
curled.
Loading Paper / Originals
Check 3: Make sure of the following when you load envelopes.
When printing on envelopes, refer to
printing.
Once you have prepared the envelopes, load them in portrait orientation. If the envelopes are placed
in landscape orientation, they will not feed properly.
Check 4: Confirm the paper source setting.
* If the paper source setting is not changed since you purchased this machine, the paper source for
plain paper is the Cassette.
Setting with the Operation Panel on the machine:
Changing the Machine Settings on the LCD
Setting with the printer driver:
Switching the Paper Source to Match the Purpose
For information on the paper source for plain paper when the Paper Source on the printer driver
is set to Automatically Select:
Setting the Paper Source for Plain Paper
Check 5: Remove the foreign object in the Rear Tray or Cassette.
Check 6: Make sure that the Inner Cover is closed completely.
Paper does not feed properly if the Inner Cover is even slightly open.
Overview of the Machine
Check 7: Clean the Paper Feed Roller.
Routine Maintenance
Note
Cleaning the Paper Feed Roller will wear the rollers, so perform this procedure only when
necessary.
Check 8: If two or more sheets of paper feed from the Cassette at once,
clean the inside of the Cassette.
> Paper Does Not Feed Properly
Loading Paper / Originals , and prepare the envelopes before
Page 730 of 805 pages