Reversing Door - Frigidaire 137111800B Installation Instructions Manual

Frigidaire gas & electric dryer installation instructions
Table of Contents

Advertisement

Available languages

Available languages

1.Open door and remove four (4) plugs in the door opening
opposite the hinges. Retain all parts for uses later, unless
otherwise noted. (Figure 1) Note: Use care in removing plugs
in not scratching paint on the front panel.
Figure 2
2. Begin removing the four (4) screws that attach the hinge to
the front panel. (Figure 2) For best results, start by only
removing one screw per hinge. Then only loosen the two
remaining screws while firmly holding door to prevent damage
to hinge, front panel or door. After the remaining screws are
loosened, continue to remove all.
3. Place door on a towel or pad handle side down to prevent
any possible scratches to door. Remove all remaining four (4)
screws between hinge and door. (Figure 3)
4. Remove four (4) screws from side of door opposite of where
hinge was mounted.
Window Door Reversal Instructions
Figure 1
Figure 3
Figure 4
5. Remove two (2) door handle screws and two (2) hole plugs
from door. Again taking care not to scratch paint on door.
(Figure 4)
Figure 5
6. Pull handle away from door assembley. (Figure 5)
7. Separate the outer door from the inner door assembly with
a putty knife or flat screw driver. (Figure 6)
14
Figure 6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gceq2170ksGlgq2170keGlgq2170ks

Table of Contents

Save PDF