General installation
1.
Connect the exhaust duct to the outside exhaust system
(see pages 4 through 6). Use of a 4" (10.2 cm) clamp (item
A) is recommended to connect the dryer to the exhaust
vent system. Use metal foil tape to seal all other joints.
2.
Carefully slide the dryer to its fi nal position. Adjust one or
more of the legs until the dryer is resting solidly on all four
legs. Place a level on top of the dryer. The dryer MUST be
level and resting solidly on all four legs. Rock alternating
corners to check for stability. Remove and discard door
tape.
Be sure the power is off at a circuit breaker/
fuse box before plugging the power cord into an outlet.
3.
Plug the power cord into a grounded outlet.
4.
Turn on the power at the circuit breaker/fuse box.
5.
Read the
Use & Care Guide provided with the dryer. It
contains valuable and helpful information that will save
you time and money.
6.
If you have any questions during initial operation, please
review the "Avoid Service Checklist" in your Use & Care
Guide before calling for service.
7.
Place these instructions in a location near the dryer for
future reference.
A wiring diagram and technical data sheet are
located inside the dryer console.
Grounding type
Grounding type
wall receptacl
wa
ll receptacle
Po Power cord with
wer cord with
3-prong gr grounded plug
3-prong
ounded plug
Do not, under
Do not,
under
an any cir
y circumstances,
cumstances,
cut, remo
cut,
remove ve,
or bypass th
or b
ypass the
gr grounding pr
ounding prong.
ong.
13
A