Download Print this page

Install Batteries - Celestron reTRACE 44850 Instruction Manual

Advertisement

Compass Mode Icon
6 Way Arrow:
Range: 22.5°
Waypoint Icons:
Press
SCROLL
key to change icon.
(Personal – Favorite – Attractions – Target – Parking)
How to Use

Install Batteries

Unscrew the latch on the back of your reTrace Lite to access
the battery compartment. Insert two "AAA" alkaline or
lithium batteries in the direction marked inside the battery
compartment. Replace cover and screw down securely.
Replace the batteries when the display's "Battery" icon
indicates low power.
Turn the unit on by pressing and holding the
3 seconds (powering outdoors with a clear view of the sky will
ensure good quality GPS reception).
2 AAA batteries
(not uncluded)
POWER
key for
The satellite icon will blink while your reTrace
Lite locks onto the GPS signal. When the icon
stops blinking, the unit is ready to use.
Compass Mode
Push the
SCROLL
key to scroll
through the icons on the bottom of the
screen and stop when the compass
icon shows. Select the Compass
mode icon by pushing the
SET
In Compass mode, a single direction
arrow points north, and the display
shows the direction you're facing in
degrees. Holding the unit flat and as
parallel as possible with the ground,
will help ensure you get a clear reading.
Set Waypoints
Your reTrace Lite can save up to 5 of your favorite Waypoints.
While standing at a location you wish to mark and return
to later, push the
SCROLL
"Location" mode icons.
(Personal/Favorite/Attractions/Target/Parking)
Select your desired Waypoint
icon. For example, if you are out
camping, you might use "Personal"
to mark your campground,
"Parking" to mark where you
left your vehicle or bike and
"Attractions" to mark a favorite
scenic spot you want to find again
later. If you like, think of the icons
as five "location memory slots"
that you can freely use for anything
you want. To mark the location and store it in the reTrace Lite's
memory under your selected location icon, hold the SET key
until the distance indication changes to "0.00".
the
POWER
key, or proceed to another location you wish to
mark. Be sure to select a different location icon before marking
this new spot, as holding the
location icon selected will replace that saved Waypoint with
your current location. When you're ready to return to one of
your previously marked locations, turn your reTrace Lite back
on by holding the
POWER
will remember all of the Waypoints you saved. To find your way
key.
key to scroll through the five
It does not matter which direction
you face when marking the location
(as a stored GPS location is just
a point or "dot"). When you move
away from that location, an arrow
points the way back to the location
(general direction relative to your
current position), and the display
shows your distance from the
location. You may now turn your
reTrace Lite off by holding down
SET
key with a previously used
key for 3 second. Your reTrace Lite

Advertisement

loading

This manual is also suitable for:

Retrace 44851Retrace lite 44850Retrace lite 44851