Advertisement
Table of Contents
Connectors:
Power Supply:
The line level remote control is a versatile means of controlling a block amplifier fed by a line level source. The
level may be controlled from a remote location via an infrared repeating system or at the front of the unit via a
manual volume control setting. The front mounted manual volume setting may also be used as a limiter to prevent
the amplifier from being overdriven by sources with very high output when controlled remotely.
To use the front mounted control as a local volume control, the remotely controlled portion of the unit needs to be
turned up to maximum via a remote control. Another feature of the RCLL-1 is a dual ramping speed when used
with a remote control. By tapping the volume up/down button on your remote control, the level changes more
quickly (in larger steps) than if the button is held down continuously. This more easily allows you to avoid
overshoot or undershoot. For example, tap on the volume up button till you are near the desired level, and then
continuously hold the button to fine tune setting.
On initial power-up the volume up button on the remote control will need to be pressed for approximately 20
seconds before sound will be heard. This is only on initial power-up or if power is lost to the system.
The RCLL-1 works with any universal remote control by using the ProScan* audio amplifier/receiver code.
Follow the wiring diagram on the back of this sheet, using quality RCA to RCA cables for the RCLL-1 to the
Amplifier connection. To connect an optional infrared receiver, strip the ends of the receiver wires and insert into
the Banana Jacks, paying close attention to the polarity of the wires.
*ProScan is a registered trademark of Thomson Consumer Electronics.
INSTALLATION MANUAL
TECHNOLOGY
Remote Controlled Line Level Volume Control
SPECIFICATIONS
Gold plated RCA type line in and line out
12 VDC (included)
AUDIOPLEX TECHNOLOGY
404 GWH P.O. BOX 440
MELVIN VILLAGE, N.H. 03850
1-800-257-2077 603-544-8601 FAX: 603-544-8901
RCLL-1
OPERATION
WIRING
www.audioplex.com
2003 - 11/20/03
Advertisement
Table of Contents
Related Manuals for Audioplex RCLL-1
Summary of Contents for Audioplex RCLL-1
- Page 1 WIRING Follow the wiring diagram on the back of this sheet, using quality RCA to RCA cables for the RCLL-1 to the Amplifier connection. To connect an optional infrared receiver, strip the ends of the receiver wires and insert into the Banana Jacks, paying close attention to the polarity of the wires.
- Page 2 Damage incurred by shipping or accident is not considered to be a defect, and not covered by this warranty. AUDIOPLEX TECHNOLOGY is not responsible for defective operation caused by abuse or by modification or service by any unauthorized person or agency.
Need help?
Do you have a question about the RCLL-1 and is the answer not in the manual?
Questions and answers