Other Functions; Setting Remote Control Code Type; Adjusting The Response Positions Of The Touch Panels (Touch Panel Calibration) - Pioneer AVH-P4150DVD Operation Manual

Other Functions

Setting remote control
code type
When the remote control operation switch is
set to DVD, changing the remote control code
type enables you to operate the Pioneer DVD
player with the supplied remote control. There
are three remote codes, code type A, code
type B and code type AVH. However, when op-
erating this unit, use the code type AVH only.
! With this unit, code A and B cannot be
used.
1 Set the remote control selection switch
on the left side of the remote control to
the appropriate position with a pen tip or
other pointed instrument .
! If you select AVH mode, there is no need to
take the following procedure.
! If you select A/B mode, take the following
procedure and change the code type to the
appropriate type.
2 Press 0 and CLEAR on the remote con-
trol simultaneously to change the code
type.
Initially, the code type is set to A. Each time
you press 0 and CLEAR simultaneously on the
remote control the code type switches be-
tween A and B.
Adjusting the response
positions of the touch panels
(Touch Panel Calibration)
If you feel that the touch panel keys on the
screen deviate from the actual positions that
respond to your touch, adjust the response po-
sitions of the touch panel. There are two ad-
justment methods: 4-point adjustment, in
which you touch four corners of the screen;
and 16-point adjustment, in which you make
fine-adjustments on the entire screen.
! Make sure to use the supplied pen for ad-
justment, and gently touch the screen. If
you press the touch panel forcefully, the
Black plate (61,1)
touch panel may be damaged. Do not use
a sharp pointed tool such as ballpoint pen
or a mechanical pen. Otherwise the screen
is damaged.
! If touch panel adjustment cannot be per-
formed properly, consult your local Pioneer
dealer.
1 Touch the source icon and then touch
Off to turn this unit off.
# When the source icon is not displayed, you
can display it by touching the screen.
2 Press and hold h (eject).
The 4-point touch panel adjustment screen ap-
pears.
3 Touch each of the arrows on the four
corners of the screen with the touch panel
adjustment pen.
# To cancel the adjustment, press and hold
MUTE.
4 Press DISP OFF/AV/NAVI to complete
the 4-point adjustment.
The adjusted position data is saved.
# Do not turn off the engine while saving the ad-
justed position data.
5 Press DISP OFF/AV/NAVI to proceed to
the 16-point adjustment.
The 16-point touch panel adjustment screen
appears.
# To cancel the adjustment, press and hold
MUTE.
6 Gently touch the center of the + mark
displayed on the screen with the touch
panel adjustment pen.
After you touch all the marks, the adjusted po-
sition data is saved.
# Do not turn off the engine while saving the ad-
justed position data.
7 Press and hold MUTE to complete the
adjustment.
CRB2901-A/N
<
Section
18
61
En
>61