l The recorder automatically jumps to the end of the
last title on the disc and starts recording.
‰ If no free space is left. The display will show
‘DISC FULL’. Safe record is not possible then.
Recordings on DVD+R are always automatically made
after the last title on the disc.
Direct Record
l Make sure ‘Direct Record’ is switched On.
(See record settings).
l On the TV set, select the programme number you
want make the recording from.
l Make sure the DVD recorder is switched to stand-
by.
l Press RECORD (on the recorder) or REC/OTR
(on the remote control).
Notes :
- Don’t select another programme number on your TV set,
until the ‘WAIT’ on the display of your DVD recorder disap-
pears. This can take up to one minute.
- When ‘NOTV’ appears on the display, the programme
number could not be found. The DVD recorder switches off
automatically.
- If your loudspeakers are connected (via an amplifier /
receiver) to your DVD recorder, the sound will be delayed rel-
ative to the TV picture when recording directly from the TV
set.
- You can use Direct Record in combination with Safe Record.
Manual audio control
You can control the audio recording level of your DVD
recorder manually.
l In tuner mode, press AUTO/MAN REC VOLUME
on the DVD recorder.
‰ The display will show the current audio level and
appears.
MANUAL
l Adjust the recording level with MANUAL 3 or 4
on the DVD recorder, so that the ‘0 dB’ mark lights
up during the loudest parts of the recording.
l You can switch back to automatic audio level control
by pressing AUTO/MAN REC VOLUME again.
‰ The display will show the current disc position
and
disappears.
MANUAL
Note :
When DV input is selected, manual volume control is dis-
abled.