Download Print this page

Changing The Outgoing Message; Skipping The Ogm For Icm Recording - Panasonic EASA-PHONE KX-T1450 Operating Instructions Manual

Auto-logic automatic telephone answering system
Hide thumbs

Advertisement

How to Operate from a Remote Phone
CHANGING
THE OUTGOING MESSAGE
You can re-record
the Outgoing
Message
from a remote phone.
1
Call your unit, and push the Code No. during
the OGM.
2
Push "7"
right after you hear the beep tones indicating
the
number
of recorded
messages.
l
Short beeps will be heard continuously
until the OGM tape has
been reset, and then a long beep will be heard.
3
Speak clearly and loudly after you hear the long beep.
4
When recording
is finished,
push "9".
l
The new Outgoing
Message
will be played back. So you can
check or amend
it.
NOTE:
If you pause for over 2 seconds
while recording,
you will hear a
series of warning
tones (6 beeps).
If this happens,
push "7" within 10
seconds
of hearing
these beeps, and repeat from step 2 again.
SKIPPING
THE OGM FOR /CM RECORDING
If you or the caller does not want to hear the Outgoing
Message,
the unit can be
switched
promptly
to the Incoming
Message
mode.
I
Call your unit.
2
Push "3~" during the OGM
3
Speak
clearly and loudly after you hear the long beep to record
your Incoming
Message.
- 18-

Advertisement

loading

  Related Manuals for Panasonic EASA-PHONE KX-T1450

This manual is also suitable for:

Easa-phone kx-t1451