Trane CGAM Installation & Operation Manual page 107

Controls Interface
Event Enable/Disable Screen
Event Active Days Screen
This screen is unusual because it does not use radio
buttons, which only allow one active selection at a time.
These buttons are more like "selection buttons" or check
boxes.The user can select any combination of days, or
none at all.
Event Time Screen
Event Arbitrated Settings Screens
For analog setpoints, the screen is slightly different than
the standard screen, because there are two additional
buttons - "Used" and "Not Used" . Selecting "Used" will
make the setting valid and allow the user to change the
value. Selecting "Not Used" will make the setting invalid,
and will not allow the user to change the value.
CG-SVX17E-EN
Table 57. Display Settings
Resolution or
Description (Enumerations), Default Units
("mmm dd, yyyy", "dd-mmm-
Date Format
yyyy"), "mmm dd, yyyy
4
Date
Time Format (12-hour, 24-hour), 12-hour
4
Time of Day
3
Keypad/Display Lockout (Enable, Disable), Disable
Display Units (SI, English), English
Pressure Units (Absolute, Gauge), Gauge
Local Atmospheric
XXX.X
Pressure:
(English, Selection 2,
1
Language
Selection 3), English (0)
(1) Language choices are dependent on what the Service Tool has setup
in the Main Processor. Get Radio Button names from Main Processor
setups. Language selections will include English and qty 2 alternate as
loaded by TechView.
(2) Temperatures will be adjustable to 0.1 deg F or C. The Main Processor
will provide the minimum and maximum allowable value.
(3) Enables a DynaView Lockout screen. All other screens time-out in 30
minutes to this screen. The DynaView Lockout Screen will have 0-9 key-
pad to permit the user to re-enter the other DynaView screens with a
fixed password. See below for further details.
(4) The Date and Time setup screen formats deviate slightly from the stan-
dard screens defined above. See the alternate screen layouts below.
(5) Language shall always be the last setting listed on the Control Settings
menu (which will also always be the last item listed on the Settings
menu list). This will allow a user to easily find language selection if look-
ing at an unrecognizable language.
(6) The pump on mode terminates after 60 minutes.
Upon selecting a Settings list all setpoints available to
change and the current value appear. Operator selects a
setpoint by touching either the verbal description or
setpoint value, causing the screen to switch to either
Analog Settings Subscreen or Enumerated Settings
Subscreen.
Analog Setting Subscreens
Analog Settings Subscreen displays the current value of
the chosen setpoint in the upper ½ of the display. It is
displayed in a changeable format consistent with its type.
Binary setpoints are considered to be simple two state
enumerations and will use radio buttons. Analog setpoints
Enum
Enum
Enum
Enum
Enum
Pressure
(always
absolute)
Enum
107