Table of Contents
Advertisement
Dialogic Boards
Basic Settings for Voice Boards
Basic Settings for Voice Boards
This step covers the basic settings for the Dialogic peripheral boards. The following voice boards
are available for installation in the Strata ACD:
•
D/4PCI
•
D/4PCIUF
•
D/120JCT-LS
Note It is recommended that the voice boards start at the D0000 memory address.
Adding or removing a board can cause the renumbering of boards in the system, depending upon
the PCI bus and slot number where you install it. Consequently the assignment of device names
may change during the next system start up.
Also, PCI boards that use ID 0 for the geographical numbering sequence will be numbered before
boards that use board IDs I-F.
Board Numbering
Important! All boards must be set to the factory default of 0.
Analog Voice Boards
D/4PCI, D/4PCIUF
Check rotary switch SW1 (shown below) to verify that it is set to 0.
SW1
SW4
J1
J2
J3
J4
Rear Bracket
Table 4-1
SW1
SW4 (D4PCI Only)
J1~J4
26
PC I
Bus Connector
D/4PCI
D/4PCI, D/4PCIUF Parts Description
Part
SW1
J1
J2
J3
J4
7438
Rear Bracket
Function
Board slot ID switch
Slide switches to set hookswitch state for start-up.
RJ11 jacks to connect to 4 PBS or public telephone
network lines.
PC I
Bus Connector
D/4PCIUF
Strata CIX ACD Installation
1pcd
06/2012
Advertisement
Table of Contents
