Toshiba Strata CIX Programming Manual page 49

Table 3-2 Telephone Systems Tab Screen Fields (continued)
F
IELD
Integration Dial Codes
Strata CIX Voice Mail Programming
D
ESCRIPTION
Voice mail controls certain actions on your telephone system by using defined
telephone system dial codes. To define the dial codes, you must modify a telephone
system dial code parameter(s).
With this option, preset dial codes for other manufacturers' systems can be enabled
or modified. The following fields display on the screen:
© Dial code to put a caller on transfer hold
© Dial code to use when there is no transfer dial tone
© Dial code to return to caller after Ring No Answer
Dial code to return to caller after Busy
©
© Dial code to use after call screening reject
© Dial code to connect the caller to the extension
© Number of milliseconds to wait for dial tone detection
© Number of milliseconds delay after flash hook
© Which DTMF tone to listen to for answer detection
© Which DTMF tone to listen to for hangup detection
What to dial AFTER dialing the user ID extension
©
© What to dial BEFORE dialing the user ID extension
© What to dial when the system first starts up
© What to dial when the system performs a shutdown
© What to dial when a port goes off-hook
© Number of minimum milliseconds to define CPM silence
© Number of minimum milliseconds to define CPM sound
Message lamp ON
©
© Message lamp OFF
© Trunk access code
© Number of milliseconds to use for Flash time
© CIX/CTX IP Address — Enter IP address assigned to the Strata CIX (LCTU)
© Simple Network Management Protocol (SNMP) Community — Enter the
community name that has been assigned in the target Strata CIX.
© IPU IP Address — change address to the one assigned to the Strata CIX (LIPU))
Note If an LIPX is installed, enter the IP of the LIPU.
01/07
Voice Mail Configuration
Telephone Systems
3-9