Ford 2009 F-250 Owner's Manual page 164

Locks and Security
Perimeter lamps illuminated entry
With the Remote Keyless Entry system, the following items will
illuminate when the control on the transmitter is pressed:
• Headlamps
• Parklamps
• Tail lamps
The lamps will automatically turn off:
• if the ignition switch is turned to the on position, or
• the Remote Keyless Entry Transmitter lock control is pressed, or
• the vehicle is locked using the keyless entry keypad (if equipped), or
• after 25 seconds of illumination.
Note: On some vehicles, the perimeter lamps illuminated entry feature
will not activate in daylight conditions.
Deactivating/activating perimeter lamps illuminated entry
You may enable/disable this feature by having your vehicle serviced by
your authorized dealer.
You may also perform the following power door lock sequence to
enable/disable the perimeter lamps feature.
Note: Before starting, ensure the ignition is in the off position and all
vehicle doors are closed.
You must complete Steps 1–5 within 30 seconds or the procedure will
have to be repeated. If the procedure needs to be repeated, wait a
minimum of 30 seconds before beginning again.
1. Place the key in the ignition and turn the ignition to the on position.
2. Press the power door unlock
control on the door panel three
times.
3. Turn the ignition from the on
position to the off position.
4. Press the power door unlock
control on the door panel three
times.
5. Turn the ignition back to the on position. The horn will chirp one time
to confirm programming mode has been entered and is active.
6. Press the power door unlock control twice within 5 seconds.
164
2009 F-250/350/450/550 (f23)
Owners Guide, 2nd Printing
USA (fus)