AOpen MX4GVR Online Manual page 36

Hide thumbs Also See for MX4GVR:
Table of Contents

Advertisement

M
X
4
G
V
R
M
X
4
G
V
R
IDE1 is also known as the primary channel and IDE2 as the secondary channel. Each channel supports two IDE devices that make
a total of four devices. In order to work together, the two devices on each channel must be set differently to Master and Slave
mode. Either one can be the hard disk or the CDROM. The setting as master or slave mode depends on the jumper on your IDE
device, so please refer to your hard disk and CDROM manual accordingly.
Tip:
1.
For better signal quality, it is recommended to set the far end side device
to master mode and follow the suggested sequence to install your new
device. Please refer to above diagram
2.
To achieve the best performance of Ultra DMA 66/100 hard disks, a
special 80-wires IDE cable for Ultra DMA 33/66/100 is required.
Warning: The specification of the IDE cable is a maximum of 46cm (18 inches);
make sure your cable does not exceed this length.
36
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents