Programming; Canadian Programming - Ford 1999 Explorer Owner's Manual

Ford motor company 1999 ford explorer owner's guide
Table of Contents

Advertisement

Programming

1. Prepare for programming the
HomeLink Universal Transceiver by
erasing the three factory default
codes by holding down the two
outside buttons until the red light
begins to flash after 20 seconds.
Release both buttons.
2. Hold the end of your hand-held
transmitter 5–14 cm (2–5 inches) away from the HomeLink Universal
Transceiver surface (located on your visor) while keeping the red light in
view.
3. Using both hands simultaneously
press and hold the hand-held
transmitter button and the desired
HomeLink button. Do not release
the buttons until step 4 has been
completed.
4. The red light will flash slowly and
then rapidly. Release both buttons
when the red light flashes rapidly.
5. Follow steps 2 through 4 to program the remaining two buttons.
If you do not successfully program the HomeLink Universal Transceiver
after repeated attempts, refer to Rolling code programing which
follows, or call toll-free customer assistance: 1–800–355–3515 or on the
Internet at HomeLink.jci.com.

Canadian Programming

During programming, your hand-held transmitter may automatically stop
transmitting after two seconds which may not be long enough to
program the HomeLink Universal Transceiver.
To program your hand-held
transmitters:
• continue to hold the button on
the HomeLink Universal
Transceiver.
• press and re-press the hand-held
transmitter button every two
seconds until the red light
changes from a slow to a fast flash.
Controls and features
REC
DEL
REC
DEL
REC
DEL
PLAY
PLAY
PLAY
93

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Explorer 1999

Table of Contents