Safety Belt Extension Assembly; Safety Belt Warning Light And Indicator Chime; Conditions Of Operation - Ford 1999 Explorer Owner's Manual

Safety belt extension assembly

If the safety belt assembly is too short, even when fully extended, 20 cm
(8 inches) can be added to the safety belt assembly by adding a safety
belt extension assembly (part number 611C22). Safety belt extension
assemblies can be obtained from your dealer at no cost.
Use only extensions manufactured by the same supplier as the safety
belt. Manufacturer identification is located at the end of the webbing on
the label. Also, use the safety belt extension only if the safety belt is too
short for you when fully extended. Do not use extensions to change the
fit of the shoulder belt across the torso.

Safety belt warning light and indicator chime

The seat belt warning light illuminates in the instrument cluster and a
chime sounds to remind the occupants to fasten their safety belts.

Conditions of operation

If...
The driver's safety belt is not
buckled before the ignition
switch is turned to the ON
position...
The driver's safety belt is
buckled while the indicator
light is illuminated and the
warning chime is sounding...
The driver's safety belt is
buckled before the ignition
switch is turned to the ON
position...
Seating and safety restraints
Then...
The safety belt warning light
illuminates for one to two minutes and
the warning chime sounds for four to
eight seconds.
The safety belt warning light and
warning chime turn off.
The safety belt warning light and
indicator chime remain off.
125