Table of Contents
Advertisement
Listening to the Radio—Continued
Selecting Preset Stations
You must store some presets before you can select them
(see pages 34 and 35).
1
Use the [BAND] or INPUT [ ]/[ ]
button to select "AM" or "FM".
The preset you selected the last time you
listened to the radio will still be selected.
or
2
Use the Previous and Next
[
preset.
Press the Previous [
the previous preset. Press the Next
[
Tip:
• You can also use the number buttons as
shown in the examples below to select
presets.
You can also use the front panel controls.
1 Use the [INPUT] button to select "AM" or "FM".
2 Turn the MULTI JOG dial to select a preset.
36
BAND
/
(PRESET
]/[
] buttons to select a
] button to select
] button to select the next preset.
To select:
Press:
Preset #8
Preset #10
Preset #22
Used to enter numbers over 10.
Tuning into weak stereo FM stations
/
)
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Noise and sound interruption can be reduced.
When returning to Auto Tuning Mode, press the ENTER
again. Normally, leave the AUTO indicator displayed.
The CD/HDD receiver automatically receives FM radio
in stereo.
FM 87.50 MHz 1 ch
AUTO indicator
FM 87.50 MHz 1 ch
Advertisement
Table of Contents
