Chapter 2 Operating Your Frequency Counter
Using the Menu
Preset
When PRESET is displayed, pressing the Enter key loads the default
settings for most of the Counter's functions. These functions and their
default settings are listed in the following table:
Table 2-1. Factory Default Function Settings
Function
Reference Oscillator
(REF OSC)
Frequency Modulation (FM)
Channel 1 Low-Pass Filter
(CH1 LPF)
Recall Settings (RECALL)
Save Settings (SAVE)
Measurement Rate
(Rate key)
Averages (Avg key)
Resolution
(Resol key)
Display Backlight On/Off
(
On/Off key)
Channel Selection
(Chan Select key)
Power Measurement Units
(dBm/W key)
Frequency Offset
(FREQ Offset On/Off key)
Relative Frequency
(Rel Freq key)
Power Offset
(POWER Offset On/Off key)
Relative Power
(Rel Pwr key)
Operating Guide
Available Settings
INT (Internal)
EXT (External)
AUTO, OFF
OFF, ON
0 through 8
0 through 8
FAST, MED,
SLOW, HOLD
01 through 99
1 Hz, 10 Hz, 100 Hz; 1KHz,
10 KHz, 100 KHz, 1 MHz
On, Off
Channel 1, Channel 2
dBm (dBm, dB)
W (W, mW, µW)
Off, On
(freq. limits depend on model)
Off, On
Off, On
(-99.99 through +99.99 dBm)
Off, On
Default Setting
INT (Internal)
AUTO
OFF
0
0
FAST
01
1 Hz
On
Channel 2
dBm
Off
(0)
Off
Off
(0)
Off
2-45