Advanced Features - Mitsubishi Electric DLP HC3900 User Manual

Advanced features

Password function
This projector is equipped with the password function
that is designed for prevention of theft and wrong
operation by children and restriction on operation by
other than specified users. The password function has
two modes as follows.
DISPLAY INPUT .......... When the projector is turned
on, the startup screen (or splash screen) will
appear and stay on the screen until the password is
entered. When the password is entered, the startup
screen will switch to the regular operation screen.
MENU ACCESS .......... All the buttons except for the
POWER button on the projector are disabled. (The
buttons on the remote control are enabled.) You can
use this mode as a measure of prevention of wrong
operation by children and restriction on operation by
other than specified users.
To enable the password function:
1. Display the FEATURE menu.
. Press the p or q button to select PASSWORD
FUNCTION.
. Press the u button to change the mode among
DISPLAY INPUT and MENU ACCESS
• When the password has already been set, the
mode won't be changed. In such cases, press
the ENTER button to cancel the password
function and try again.
4. Press the ENTER button.
• The screen for setting the password function will
appear.
DISPLAY INPUT
LOCK
UNLOCK
5. Press the ENTER button.
• The screen for entering a password will appear.
PASSWORD
CONFIRM
1
4 2
3
6. Enter a 4 - 8 digit password using the p, u, q or t
buttons on the remote control as shown below.
( p=1, u=, q=, t =4)
7. Press the ENTER button.
• To cancel the procedure, press the MENU
button.
8. Enter the password again for confirmation using the
same steps.
9. Press the ENTER button.
• If the entered passwords don't match, an error
message will appear.
• To cancel the procedure, press the MENU
button.
.
OK
OK
O K : ENTER CANCEL : MENU
To cancel the password function:
1. Display the FEATURE menu.
. Press the p or q button to select PASSWORD
FUNCTION.
. Press the ENTER button.
• The screen for canceling the password function
will appear.
DISPLAY INPUT
4. Press the ENTER button.
• The screen for entering the password will
appear.
PASSWORD
4
5. Enter a 4 - 8 digit password using the p, u, q or t
buttons on the remote control as shown below.
( p=1, u=, q=, t =4)
6. Press the ENTER button.
• If you enter a wrong password, an error
message will appear.
• To cancel the procedure, press the MENU
button.
Important:
• Disable the password by pressing the MENU and
ENTER buttons on the control panel at the same
time about three seconds.
Kensington Lock
This projector has a Kensington Security Standard
connector for use with Kensington MicroSaver Security
System. Refer to the information that came with the
Kensington System for instructions on how to use it
to secure the projector. Please contact Kensington
Technology Group below.
Kensington Technology Group
855 Campus Drive
San Mateo, CA 9440, U.S.A.
Phone: +1- (650)57-700
Fax: +1- (650)57-9675
EN-5
OK
LOCK
UNLOCK OK
1
2
O K : ENTER CANCEL : MENU
3